Alfa Romeo 8c, 08 Airbag Fault Code - Air Bag Fault Codes

Alfa Romeo 8c, 08 airbag fault code :

This page is about Alfa Romeo 8c air bag problem code 08.

The possible SRS 08 airbag error reason/s; Firing circuit side airbag left side

#08 Airbag Code Repair order ("Recheck SRS at each replacement.")

Visually check the wiring harness connection. Replace the harness if it has visible damage. Replace side air bag module (LH).(Before disposal, it must be deployed.) Replace the diagnosis sensor unit.

How to disable Alfa Romeo 8c airbag module ?

1. Remove ash tray from console panel
2. Using a socket set, remove 4 hex head screws from console panel
3. Pull console panel out of the two clips
4. Remove connector from Passenger Airbag Disable module in console panel and take console panel to a work bench
5. Remove 2 phillips head screws to remove the airbag key module
6. Carefully unclip the plastic tabs that hold the airbag key module case together
7. Remove circuit board from airbag key module housing
8. To prepare the module housing I drilled a 1/4" hole through the clear lens allowing my particular LED to be attached through that hole
9. Now carefully unsolder the blown light bulb
10. Then you are able to solder on the new LED *polarity matters* with that in mind the negative on the circuit board is closest to the outer edge of the circuit board
11. Reassemble the PAD Module and put it back into the console panel and then put everything back together on the dash in the reverse order of removal.

How to clear Alfa Romeo 8c 08 airbag code ?

1. Follow the diagnostic procedures to service the fault condition flashing on the air bag indicator prior to code clearing.
2. Cycle the ignition switch to OFF and then to RUN.
3. Observe air bag indicator prove-out (six ? two seconds) followed by diagnostic trouble code (52-85) flashing completely one time.
4. Locate the Diagnostic "Trouble Code Clear" Connector (grey connector). located underneath the glove compartment, left side (06010) containing Circuits 631 (T/R) and 57 (BK).
5. Use a jumper wire to short Circuit 631 (T/R) to Circuit 57 (BK) or to another good ground. This short must be made after the diagnostic trouble code flashes completely one time, but before the warning light stays on continuously.
6. Hold short until air bag diagnostic monitor tone sounds (approximately five seconds).
7. Release short on Circuit 631 (T/R) to Circuit 57 (BK). This short must be released within 25 seconds after the diagnostic monitor tone sounds.

Diagnostic trouble code is now cleared from memory. Airbag Code Repair order Disabling and removal of Alfa Romeo 8c airbag module Clear Alfa Romeo 8c 08 airbag code

Airbag Codes

• 01
• 02
• 03
• 04
• 05
• 06
• 07
• 08
• 09
• 10
• 11
• 12
• 13
• 14
• 15
• 16
• 17
• 18
• 19
• 20
• 21
• 22
• 23
• 24
• 25
• 26
• 27
• 28
• 29
• 30
• 31
• 32
• 33
• 34
• 35
• 36
• 37
• 38
• 39
• 40
• 41
• 42
• 43
• 44
• 45
• 46
• 47
• 48
• 49
• 50
• 51
• 52
• 53
• 54
• 55
• 56
• 57
• 58
• 59
• 60
• 61
• 62
• 63
• 64
• 65
• 66
• 67
• 68
• 69
• 70
• 71
• 72
• 73
• 74
• 75
• 76
• 77
• 78
• 79
• 80
• 81
• 82
• 83
• 84
• 85
• 86
• 87
• 88
• 89
• 90
• 91
• 92
• 93
• 94
• 95
• 96
• 97
• 98
• 99

Other Alfa

• Alfa Romeo 1600
• Alfa 40-60
• Alfa Romeo 2000
• Alfa Romeo Rm
• Alfa Romeo Long
• Alfa Romeo 175
• Alfa Romeo 2900
• Alfa Romeo Gta
• Alfa Romeo 159
• Alfa Romeo 145
• Alfa Romeo 1900
• Alfa Romeo 6c
• Alfa Romeo Rl
• Alfa Romeo 166
• Alfa Romeo Alfetta
• Alfa Romeo Mito
• Alfa Romeo Alfa
• Alfa Romeo Gt
• Alfa Romeo Arna
• Alfa Romeo 8c

All rights reserved. Copyright © 2017

About Us | Contact | Privacy