| I2cDiscreteIoExpander v4.0.1 Arduino library for TI PCF8575C 16-bit I2C I/O expander. |
Arduino library for TI PCF8575C 16-bit I2C I/O expander. Version4.0.1 Date27 Sep 2016 Source Code Repositoryhttps://github.com/4-20ma/I2cDiscreteIoExpander Programming Style Guidelineshttp://geosoft.no/development/cppstyle.html FeaturesThe PCF8575C provides general-purpose remote I/O expansion for most microcontroller families via the I2C interface serial clock (SCL) and serial data (SDA). The device features a 16-bit quasi-bidirectional input/output (I/O) port (P07..P00, P17..P10), including latched outputs with high-current drive capability for directly driving LEDs. Each quasi-bidirectional I/O can be used as an input or output without the use of a data-direction control signal. At power on, the I/Os are in 3-state mode. The strong pullup to VCC allows fast-rising edges into heavily loaded outputs. This device turns on when an output is written high and is switched off by the negative edge of SCL. The I/Os should be high before being used as inputs. After power on, as all the I/Os are set to 3-state, all of them can be used as inputs. Any change in setting of the I/Os as either inputs or outputs can be done with the write mode. If a high is applied externally to an I/O that has been written earlier to low, a large current (IOL) flows to GND. The fixed I2C address of the PCF8575C (0x20) is the same as the PCF8575, PCF8574, PCA9535, and PCA9555, allowing up to eight of these devices, in any combination, to share the same I2C bus or SMBus. Schematic Arduino .--------------------. |Duemilanove | | | TI PCF8575C .---------o|5V | .-------_-------. | | | -o|1 /INT VCC 24|o--' o-----o|GND | | | | | | .------o|2 A1 SDA 23|o------)-----o|A4 SDA | | | | | | | o------o|3 A2 SCL 22|o------)-----o|A5 SCL | | | | | '--------------------' | -o|4 P00 A0 21|o------o | | | | | -o|5 P01 P17 20|o- | | | | | | -o|6 P02 P16 19|o- | | | | | | -o|7 P03 P15 18|o- | | | | | | -o|8 P04 P14 17|o- | | | | | | -o|9 P05 P13 16|o- | | | | | | -o|10 P06 P12 15|o- | | | | | | -o|11 P07 P11 14|o- | | | | | o------o|12 GND P10 13|o- | | '---------------' | | | '-------------------------------o | | === GND CaveatsConforms to Arduino IDE 1.5 Library Specification v2.1 which requires Arduino IDE >= 1.5. SupportPlease submit an issue for all questions, bug reports, and feature requests. Email requests will be politely redirected to the issue tracker so others may contribute to the discussion and requestors get a more timely response. AuthorDoc Walker (
[email protected]) Copyright2009-2016 Doc Walker License Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0 Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License. - Generated by
1.8.12