Easy Cleaning - Clogged 3D Printer Nozzle : 6 Steps (with Pictures)

Home » How To Clean 3d Printer Nozzle » Easy Cleaning - Clogged 3D Printer Nozzle : 6 Steps (with Pictures)

Maybe your like

Introduction: Easy Cleaning - Clogged 3D Printer Nozzle

Cleaning a clogged nozzle is very hard at times. This is an easy and cheap method to clean clogged nozzle.

Step 1: Things You Need

1. Acetone (Nail polish remover)

2. Candle or Lighter

3. Needle

4. Aluminium foil

Step 2: Dip the Nozzle in Acetone

The higher the concentration of acetone lesser the time required.

I use nail polish remover because they are cheap and easy to get.

Leave it for 20-30 minutes.

Step 3: Clean the Big End Using Needle

Remove the plastic using a needle.

There will be plastic left over a the tip which cannot be cleaned using needle.

Step 4: Wrap the Nozzle

Wrap the nozzle in Aluminium foil. Leave the top end open so that the fumes can go out.

Step 5: Bring It Near to Flame

Hold the nozzle into the flame for around 5 minutes. Remove foil and check the nozzle

- If there is still plastic heat it again.

- If it is clean then wash the nozzle and remove any leftovers using needle.

Step 6: Thats It..:-)

Hold it near to any light source and check whether it is clean.

Hide

Tag » How To Clean 3d Printer Nozzle