Glacial Landform - Glacial Deposition - Britannica

Cirques, tarns, U-shaped valleys, arêtes, and horns

The heads of most glacial valleys are occupied by one or several cirques (or corries). A cirque is an amphitheatre-shaped hollow with the open end facing down-valley. The back is formed by an arcuate cliff called the headwall. In an ideal cirque, the headwall is semicircular in plan view. This situation, however, is generally found only in cirques cut into flat plateaus. More common are headwalls angular in map view due to irregularities in height along their perimeter. The bottom of many cirques is a shallow basin, which may contain a lake. This basin and the base of the adjoining headwall usually show signs of extensive glacial abrasion and plucking. Even though the exact process of cirque formation is not entirely understood, it seems that the part of the headwall above the glacier retreats by frost shattering and ice wedging (see below Periglacial landforms). The rock debris then falls either onto the surface of the glacier or into the randkluft or bergschrund. Both names describe the crevasse between the ice at the head of the glacier and the cirque headwall. The rocks on the surface of the glacier are successively buried by snow and incorporated into the ice of the glacier. Because of a downward velocity component in the ice in the accumulation zone, the rocks are eventually moved to the base of the glacier. At that point, these rocks, in addition to the rock debris from the bergschrund, become the tools with which the glacier erodes, striates, and polishes the base of the headwall and the bottom of the cirque.

During the initial growth and final retreat of a valley glacier, the ice often does not extend beyond the cirque. Such a cirque glacier is probably the main cause for the formation of the basin scoured into the bedrock bottom of many cirques. Sometimes these basins are “over-deepened” several tens of metres and contain lakes called tarns.

In contrast to the situation in a stream valley, all debris falling or sliding off the sides and the headwalls of a glaciated valley is immediately removed by the flowing ice. Moreover, glaciers are generally in contact with a much larger percentage of a valley’s cross section than equivalent rivers or creeks. Thus glaciers tend to erode the bases of the valley walls to a much greater extent than do streams, whereas a stream erodes an extremely narrow line along the lowest part of a valley. The slope of the adjacent valley walls depends on the stability of the bedrock and the angle of repose of the weathered rock debris accumulating at the base of and on the valley walls. For this reason, rivers tend to form V-shaped valleys. Glaciers, which inherit V-shaped stream valleys, reshape them drastically by first removing all loose debris along the base of the valley walls and then preferentially eroding the bedrock along the base and lower sidewalls of the valley. In this way, glaciated valleys assume a characteristic parabolic or U-shaped cross profile, with relatively wide and flat bottoms and steep, even vertical sidewalls. By the same process, glaciers tend to narrow the bedrock divides between the upper reaches of neighbouring parallel valleys to jagged, knife-edge ridges known as arêtes. Arêtes also form between two cirques facing in opposite directions. The low spot, or saddle, in the arête between two cirques is called a col. A higher mountain often has three or more cirques arranged in a radial pattern on its flanks. Headward erosion of these cirques finally leaves only a sharp peak flanked by nearly vertical headwall cliffs, which are separated by arêtes. Such glacially eroded mountains are termed horns, the most widely known of which is the Matterhorn in the Swiss Alps.