How To Bleed Motorcycle Brakes | Motorcyclist

Maybe your like

Replacing your brake fluid and bleeding the system of air bubbles is regular maintenance that your owner’s manual will likely suggest doing once every two years. Brake fluid needs to be replaced because it degrades with use—water gets absorbed out of the air and reduces the boiling point, and air bubbles can sneak past the seals and make the lever spongy. Replacing the fluid solves both of those issues, and we walk you through the entire process in how to bleed your motorcycle brakes tutorial from MC Garage.

Remove The Cap And Diaphragm

Clean and remove the reservoir’s cap.©Motorcyclist

Before you start removing bolts and flushing fluid, take a second to wipe down your brake reservoir, calipers, and brake lines with a clean rag. This will ensure that you aren’t contaminating your pads or getting dirty fingerprints all over your bike. When everything is wiped down, go ahead and turn the handlebar so the fluid within the reservoir is level. Then carefully remove the cap and diaphragm and set both aside on a clean towel, taking note of the condition of the diaphragm. If it is worn, cracked, or torn order a replacement.

Prepare The Bleed Nipple On The Caliper

Pressurize, rinse, repeat.©Motorcyclist

Pump the brake lever to pressurize the system and—with the lever still pulled in—crack the bleeder screw just loose enough to allow the pressurized fluid to escape. Allow the lever to come almost back to the bar then close the bleeder bolt. Don’t release the lever until you’ve closed the bleeder bolt. Keep an eye on the fluid level in the reservoir as you repeat this step.

Top Up The Reservoir As Needed

Refill the brake fluid reservoir constantly to ensure you don’t get any air in the brake lines.©Motorcyclist

Repeat the previous step until the brake fluid reservoir is almost empty. Refill it with new brake fluid until fresh, clear fluid is seen in the hose; it could take dozens of tries so be patient. Do not let the reservoir go empty if you do allow it to run dry it will introduce air into the master cylinder and the bleeding process will take a lot longer.

Refill the brake fluid reservoir constantly to ensure you don’t get any air in the brake lines.©Motorcyclist

Tighten The Bleeder Bolt And Clean Up

You did it! Time to take the bike out for a spin around the block to ensure proper brake function.©Motorcyclist

Finally, tighten the bleeder bolt, remove the hose, fill the reservoir to the proper level, reinstall the diaphragm and cap, and you’re done. Brake fluid does nasty things to paint, so make sure to wipe up any spills with a damp rag. Before you set out on for a transcontinental adventure, take the bike out around the block, testing the brakes and lever feel. If the lever feels spongy, you introduced air bubbles into the line and need to start over.

More Mc Garage

Mc GarageWhat Is The Best Adventure Motorcycle Tire Pressure?
Mc GarageHow To Clean Your Motorcycle Fuel Pump
Mc GarageHow To Clean Your Fuel Injectors
Mc GarageGetting A Motorcycle Roadworthy How-To Part 1
Mc GarageHow To Service A Motorcycle Swingarm And Suspension Linkage

Latest

NewsDucati DesertX V2 2026 First LookNewsInterview: Indian’s New CEO Mike KennedyNews2026 Kawasaki KLX300R First LookNewsNew-Generation KTM 790 Duke Leaked Ahead of LaunchNews2026 MV Agusta Rush Titanio First LookNews2026 Ducati Formula 73 First LookNewsTVS RTR HyprStunt Might Bring Stunt Bike Style to ShowroomsNewsGeorge Barber Jr., Barber Vintage Motorsports Museum Founder, Dies At 85News2026 Kawasaki KX85, KX85 L, and KX112 First Look