How To Clean The Swimming Pool Filter Sand And Backwash - Pahlen

Home » How To Clean Pool Sand Filter » How To Clean The Swimming Pool Filter Sand And Backwash - Pahlen

Maybe your like

Pahlen Pahlen Skip to content
  • Showroom
  • Products
    • Water circulation
      • Pumps
    • Water attractions
      • Counter currents
      • Jet Massage
    • Pool heating
      • Heat exchangers
      • Electric heaters
    • Swimming pool equipment
      • Lights
      • Inlet and outlets
    • Measuring & dosing system
      • Automatic chemical dosing system
      • CO2 pH regulation
      • Ultraviolet cleaning Auto-UV
    • Water quality
      • Test instruments
    • Product line
      • Marine line
      • Classic line
  • Users guide
    • Starting up
    • Pool circulation system
    • Chemical cleaning
    • Balanced water
    • Test kit
    • pH and chlorine
    • Routines for water care
      • 1. pH levels
      • 2. Disinfection
      • 3. Flocculation
      • 4. Cleaning and vacuuming
    • Total alkalinity – Calcium hardness
    • Bromine
    • Clean the filter sand
    • Common pool questions
    • Closing down the for the winter
  • Distributors
  • Swimming pool catalogue
Cleaning and backwash the filter

In order for your sand filter to work optimally, it is important to clean the filter sand regularly.

After about 5-10 days, or when the reading of the pressure gauge on the pump side of the filter has increased by about 0.2 bars (20 kPa, 3 psi) since the last backwash, backwash the filter as follows:

  1. Stop the pump.
  2. Close the valves on the suction and return lines.
  3. Open the cover of the pump and empty the filter basket.
  4. Refit the cover.
  5. Open the valve to the drain outlet.
  6. Turn the lever to BACKWASH.
  7. Open the valves to the suction and return lines.
  8. Start the pump. Rinse the filter for about 1 to 2 minutes or until the water in the sight glass is clear. NOTE: Any electric heater must be off.
  9. Stop the pump.
  10. Turn the lever to RINSE, start the pump and rinse for about 15-30 seconds. Stop the pump and turn the lever to FILTER. This is the normal operating position
  11. Close the drain outlet valve and start the pump. Switch on the electric heater if any.

Positions of the backwash valve FILTRATION  – Normal filtering position BACKWASH  – Cleaning the filter sand RINSE  – Stabilizing the filter sand WASTE  – For vacuum cleaning the bottom of the pool directly to drain, or for emptying the pool CLOSED  – Closed CIRCULATION – Pumping water directly to the pool (no filtering)

Tag » How To Clean Pool Sand Filter