How To Drill A Hole In Tile - Quick Tip - Bob Vila
Maybe your like
Home Advice You Can Trust
Tips, tricks & ideas for a better home and yard, delivered to your inbox daily.
Email address Sign Up Thank you!Terms of Service & Privacy Policy
Cutting a hole through the glazed surface of ceramic tile can be tricky, as the glaze is slippery and ceramic is breakable. But if you need to mount a towel rack or toilet paper holder on an existing tiled wall, it’s an unavoidable task, as the anchor screws for the fixtures have to get through the tile and into the stud or backer board behind it.
Luckily, a little help from a DIY staple can make the process much easier.
The key to keeping your drill from slipping and sliding is as simple as a strip of painter’s tape. This non-damaging adhesive gives your bit traction and prevents it from meandering all over the tile, which can mark up your surfaces with unsightly scratches. And, unlike masking tape, it won’t leave gummy residue in its wake.
- To start, make a cross with two pieces of painter’s tape at the drill site.
- Use a permanent marker to draw a dot on the tape where the hole must go.
- Next, create a starter hole by gently tapping a center punch on the dot to penetrate just below the surface of the glaze.
- Outfit your drill with a carbide-tipped masonry bit of the appropriate size.
- Set your power tool to the lowest speed.
- Apply moderate pressure as you proceed, working slowly to avoid splitting the tile.
If the bit starts to overheat, lubricate it with water or cutting oil every 15 to 30 seconds. You can spray the tip of the bit with water as you drill, or dip the tip in cutting oil, remembering to wipe off any residue before resuming.
Once you’ve made it through the tile, remove the tape to reveal a clean hole that’s ready to take on its new fixture.
Meet the 2025 Tools of the Year
After months of scouring the market and putting products through their paces, we’ve named the best of the best in new tools. There’s something for everyone, from veteran pros to average Joes.
SEE THE WINNERSTag » How To Drill Through Tile
-
How To Drill Through Ceramic Tile With Ease - This Old House
-
How To Drill Through Tiles Without Cracking Them - Tile Mountain
-
How To Drill A Hole In A Tile - TOO EASY! - YouTube
-
How To Drill Through Tiles Without Cracking Them - YouTube
-
7 Easy Steps For Drilling Into Tile - Rubi
-
HOW TO DRILL INTO TILES WITHOUT BREAKING THEM?
-
How To Drill Into Tile And What Drill Bit To Use For Tiles - CTD Tiles
-
Modern Fixes: How To Drill Through A Tile Without Damaging It
-
How To Drill Through Tiles - British Ceramic Tile
-
How To Drill Into Tiles - Bunnings Australia
-
Drilling Through Tile Can Be An Easy DIY - Homedit
-
How To Drill Into Tile - Crown Tiles
-
How Can I Drill Through Very Hard Porcelain Tile? - DIY Stackexchange
-
How To Drill Ceramic Tile (with Pictures) - WikiHow