How To Drill Out A Rivet | EHow

Share

1. Home Sweet Home
2. Home Maintenance & Repairs

How to Drill Out a Rivet By Doug Berthon eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

• Drill

• Drill bit

• Nail or metal punch

Many rivets are drilled out in less than a minute.

A common use of rivets is to fasten thin materials together, such as sheet metal or plastic. It is often impractical or undesirable to screw thin materials together because they can be pulled apart easily. Rivets supply a cap and pressure to both sides to provide holding power. Drilling out a rivet is a simple process that usually takes less than a minute, unless your rivet is large and solid. In such cases, do not worry. They also can be drilled out.

Advertisement

Aluminum Rivets

Step 1

Use a drill bit the same size as the shaft of the rivet.

Choose a drill bit the same size as the shaft of the rivet and insert it into the drill. The bit size need not be as large as the head of the rivet itself.

Advertisement

Related Stories

Home Sweet Home How to Glue a CPVC Pipe Home Sweet Home How Do I Disassemble a Moen 103258 Faucet? Home Sweet Home How to Tell a Trailer Axle Size

Video of the Day

Step 2

Position the drill bit on the head of the rivet and continue to drill until the head falls off.

Step 3

A metal punch or nail set is used to align holes or to remove remnants of the rivet.

Remove the remains of the rivet with a nail set.

Advertisement

Solid Rivets

Video of the Day

Step 1

Choose a drill bit the same size as the shaft of the rivet and insert it into the drill.

Step 2

Position the drill bit on the head of the rivet and continue to drill until the head is removed. If you are unable to center the drill bit on the head of the rivet, use a sharp punch to dimple the center point. If the head will not disappear from drilling, you may need to use a larger bit. If you must install a new rivet, be careful not to over-size the hole.

Advertisement

Step 3

Hammer out the remaining part of the rivet with a metal or nail punch. Support the backside if there is a possibility of denting the surface.

Advertisement

references

• On the House: Holding Things Together
• Integrated Publishing: Rivet Replacement

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

you may like

1

How to Pull Out a Dented Bumper

2

How to Size Machine Screws

3

How to Reset a Chamberlain Security Keypad

You May Also Like

1

How do I Move a Shower Drain to the Center for Installation?

2

How to Hook Up Alpine 2-Way Crossovers

3

How to Fix a Small Hole in a Water Heater