How To Remove Tire From Rim? Step By Step Guide - Tireer

Removing tires is a matter for the professional. Because if you do not do it right, you can seriously damage tires and rims and endanger your safety. If you have a lot of manual skills and are an accomplished screwdriver, you can lift the tire from the rim by hand with an assembly iron (better with two).

Step 1: Move the vehicle to a spacious location

Removing a tire can be annoying. So, it is dangerous to do it in the middle of the road. It is because you may get stuck in the middle of the road while riding. Hence, please move to a spacious position to remove the tires.

Step 2: Disassemble the valve and the tire

On the tire, there will be a piece of rubber that is the air valve. In this step, screw the valve cap in the counterclockwise direction. Using the valve remove tool will deflate the tire. After performing the above operations, place the tire on the ground to remove the tire.

Step 3: Break the tire bead

Tires and rims are always fastened together with special glue. Use strong glue and seal so that they do not fall off. When you want to remove a tire, break the glue and stick the tire to the rim firmly. To break the grain of the wheel, you have two ways: manual tools as use a large flat-tip screwdriver or use your strength.

Step 4: Disassemble the old tire

When making the removal of tires that are prone to slippage, place a mat under the tire. Use foot force on both sides of the tire to reduce the chance of scratches and increase leverage. While removing the tire from the place, you may need to apply some hard grease to the surface.

Step 5: Use a little oil or soap

After removing the tire from the rim, you will install a new tire. So you need to use oil to apply the inside of the tire to avoid scratching the rims. If there is no oil, you can replace it with another liquid such as soap.

Step 6: Put new tires on the rims

You may now want to put new tires on the rims so you can continue to use them. You can use specialized tools if you do not have time. Inflate your tires and use them right away.

What to do with old tires?

If you want to reuse the tire, we should place a pressure piece with rounded corners between the other vice jaw and the tire rubber. Otherwise, the sharp edges will damage the flanks. The pressure point of the vice should be very close to the rim shoulder.

It requires the mentioned mounting iron to pull it off. First, you press the tire on one side with both hands firmly into the low bed and then push it to the opposite side. There you put the tire iron on and lever the rubber over the rim flange with little effort.