Top Most 15+ How To Set Cutting Torch

1.Oxy Acetylene Cutting Torch Setup - YouTube

Duration: 7:48 Posted: 17 Jun 2017 VIDEO

View more »
2.How To Set Up And Operate A Cutting Torch - YouTube

Duration: 2:55 Posted: 7 Aug 2017 VIDEO

View more »
3.Setting Up And Shutting Down An Oxy-fuel Cutting Torch System.

Duration: 7:32 Posted: 22 Apr 2019 VIDEO

View more »
4.How To Set Up An Oxy Acetylene Torch (with Pictures) - WikiHow

Rotate the pressure-adjusting screw to the left until it turns freely. Do this for each regulator. The valve in the regulator needs to be closed before cylinder ...

View more »
5.How To Use A Cutting Torch (with Pictures) - WikiHow

Most manufacturers recommend shutting off the the fuel torch valve first, then the oxygen torch valve. Then close both the oxygen and fuel tank valves. Next, ...

View more »
6.Oxy Acetylene Cutting Torch Pressure Settings (Regulator Gauge)

The recommended setting is for the fuel gas regulator to be set at 10 PSIG and the oxygen regulator at 45 PSIG. This recommendation applies when cutting less ...

View more »
7.How Do I Set Up An Oxy Acetylene Torch? - Quora

Open the oxygen cylinder valve all the way. · Open the Acetylene cylinder valve all the way. · Open the torch acetylene valve, just enough to get a moderate flow.

View more »
8.How To Use A Oxygen Acetylene Cutting Torch - B+C Guides - Brit + Co

Use a Oxygen Acetylene Cutting Torch ; Gather your supplies. ; Measure and mark your cutting path. ; Open your oxygen bottle all the way. ; Open your acetylene ...

View more »
9.How To Set Up A Cutting Torch Safely And Efficiently - Welding Stars

How to Set Up a Cutting Torch Safely and Efficiently · Start to preheat, point tip at an angle on edge plate · Rotate tip to an upright position · Press oxy valve ...

View more »
10.How To Properly Light, Adjust And Shut Down An Oxy–acetylene Torch

Make sure regulator pressure adjustment screws are backed out! · Make sure torch valves are closed! · Stand away from front of regulator · Separately and slowly ...

View more »
11.[PDF] Setup And Shutdown Procedure For Oxy- Fuel Cutting Torch

THE INSTRUCTOR TURNS THE VALVE FOR THE ACETYLENE TANK. 6. Adjust the pressure valve to needed pressure. In the video, 5 psi is needed for the torch. If you.

View more »
12.: ABN Oxygen & Acetylene Torch Kit – 10 Pc Welding ...

Rating 4.2 (296) · US$71.99 · In stock Amazon.com: ABN Oxygen & Acetylene Torch Kit – 10 Pc Welding Kit Metal Cutting Torch Kit, Portable Cutting Torch Set Welder Tools : Tools & Home ...

View more »
13.Regulator Settings For Cutting - American Welding Society

For 3/16" to 1/4" thick steel using a #0 cutting tip, your settings should be about 30 psi for oxygen, and about 4 psi for acetylene. At 12 psi ...

View more »
14.How To Set Up An Oxy-Acetylene Torch - It Still Runs

Light the torch with a spark lighter and adjust the acetylene valve on the torch handle and the oxygen valve on the cutting torch until the flame has no yellow ...

View more »
15.Cut The Crap: Beginners Guide To Cutting With An Oxy-Acetylene ...

23 Apr 2021 · Oxy-Acetylene Torch Set-Up: Step by Step · Slowly, and one at a time, open the valves on both tanks. · Adjust the screws on the regulators so the ...

View more »

Contact