How To Test A Manifold's Absolute Pressure Map Sensor - It Still Runs

Home » How To Test The Map Sensor » How To Test A Manifold's Absolute Pressure Map Sensor - It Still Runs

Maybe your like

How to Test a Manifold's Absolute Pressure Map Sensor by Don Bowman itstillruns article image Jupiterimages/Comstock/Getty Images

The manifold absolute pressure sensor, or MAP sensor, is generally used in place of the mass airflow sensor in an automobile. It preceded the mass airflow sensor and was much less efficient. The MAP sensor measures the pressure in the intake manifold through a vacuum. The more pressure, the lower the vacuum and the lower the voltage output. The lower the pressure, the higher the vacuum and the higher the voltage output signal. The mass airflow measures the volume of air moving into the manifold.

Step 1

Connect the voltmeter to the MAP sensor by connecting the black lead to a good ground and connecting the red lead to the center of the three wires in the MAP sensor's electrical connector.

Step 2

Turn the ignition key on with the engine off. The voltage displayed on the voltmeter should be between 4.5 to 5 volts.

Step 3

Start the engine and the voltage displayed should be .5 to 1.5 volts at sea level or close. The voltage will decrease as altitude increases. If the voltage differs greatly on either test, the MAP sensor is fried. Replace it.

Things You'll Need

  • Voltmeter

Writer Bio

Don Bowman has been writing for various websites and several online magazines since 2008. He has owned an auto service facility since 1982 and has over 45 years of technical experience as a master ASE tech. Bowman has a business degree from Pennsylvania State University and was an officer in the U.S. Army (aircraft maintenance officer, pilot, six Air Medal awards, two tours Vietnam).

More Articles

itstillruns related article image How to Reset a S550 Maintenance Message itstillruns related article image The Location of the Coolant Temp Sensor ... itstillruns related article image How to Disable the Alarm on a 2007 Camry itstillruns related article image How to Reset the MAINTENANCE REQUIRED ... itstillruns related article image How to Reset the Computer in a 2005 GMC itstillruns related article image How to Disable the Alarm on a 1997 Camry itstillruns related article image How to Disable a Factory Alarm on a ... itstillruns related article image How to Test a Faulty Coil Pack itstillruns related article image How to Check the TPS Voltage on a Chevy ... article divider ×

Tag » How To Test The Map Sensor