Jacks Required To Lift A House - EHow

Share

1. Home Sweet Home
2. Carpentry & Remodeling

Jacks Required to Lift a House By Keith Allen eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Lifting a home requires some mechanical power in the form of a jack. Jacks use the principle of mechanical advantage to increase lifting power. when lifting a home, hydraulic bottle jacks are most commonly used, although screw jacks are also used. The number and size of the jacks is dependent on the size and configuration of the home.

Advertisement

Lifting a Corner

Video of the Day

If only a portion of the house has settled, a single jack might be enough. A 12-ton hydraulic bottle jack placed on a set of beams and lifting against a beam run perpendicular to the floor joists should raise a corner or side of a house. Work slowly and lift only 1/8 inch per day to prevent cracks to drywall or plaster.

Advertisement

Related Stories

Home Sweet Home Sand & Gravel Uses Home Sweet Home How to Connect Roof to Concrete Block Wall Home Sweet Home How to Mount a Flat Screen TV in an Existing Entertainment Center

Video of the Day

Whole House Lifts

Lifting an entire square or rectangular house requires at least four jacks. Houses of other shapes or larger homes may require more jacks. Place beams under the house perpendicular to the floor joists. Place another set of beams under these. Jacks at each end of these beams lift the house. Movers may use larger jacks but four 12-ton bottle jacks should lift most homes.

Advertisement

Building a Support

Bottle jacks stand about 1 foot tall and extend less than that. Often a support structure is required. Place two 4-by-4 or 6-by-6-inch beams parallel to each other about 24 inches apart. Place two more beams perpendicular to the first on top of the ends of the first beams. Continue alternating the beams until reaching the necessary height. This is called a crib. Raise the house slightly above the planned elevation with the jack and build the crib to the correct height.

Advertisement

Permanent Jacks

Support posts with screw jacks built in are called lally columns. After a house is lifted to its new elevation the lally is placed as permanent support, if necessary, and the screws adjusted to the proper height. Place the lally so it supports a beam that runs under multiple floor joists to support a larger portion of the home. The base of the lally should rest on a portion of the foundation of the home.

Advertisement

references

• Hammer Zone: Raising a Slightly Sagging Floor; Bruce Maki
• FEMA: Elevating Your House

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

you may like

1

How to Build With Used Tires

2

How to Notch a Wood Beam

3

How to Install Paneling in Trailers

You May Also Like

1

How to Install a Metalbestos Chimney Pipe

2

Step-by-Step Plans on How to Build a Deck

3

How to Cut Church Pews