Nano 33 BLE Not Able To Communicate Using TX/RX - Arduino Forum

Maybe your like

Projects Networking, Protocols, and Devices skippy26 December 16, 2020, 9:36pm 1 Hello!I'm working on a project where I have a Nano 33 BLE that is suppose to send data to a TTL->RS232 converter and then the RS232 signal is sent to other hardware, but the TX pin doesn't seem to send any data.I'm very confident that the converter works and it seems like this is a problem with the Nano. I currently have 5V going into the VIN pin and ground is hooked up too so it shouldn't be attempting to send the data over a usb cable. When I do have a USB cable attached, it prints to the serial monitor just fine. Here's some code I've used to test it:With this code running, it doesn't seem like anything is sent by the TX pin. If I hook up a multimeter to the TX pin then it always reads 3.3V (Which I believe means that it's done sending data or not sending data at all) and it doesn't fluctuate at all.Is there something special in code that I need to do? Is this a hardware problem?Thank you for your help! Klaus_K December 16, 2020, 10:15pm 2 On the Arduino Nano 33 BLE and IoT Serial is used by the virtual COM over USB. USB is handled by the microcontroller directly. If you want to use the hardware UART you need to use Serial1. skippy26 December 17, 2020, 1:24am 3

Klaus_K: On the Arduino Nano 33 BLE and IoT Serial is used by the virtual COM over USB. USB is handled by the microcontroller directly. If you want to use the hardware UART you need to use Serial1.

That worked! Thank you! Related topics

Topic

Replies

Views

Activity

Arduino nano 33 BLE UART communication issue Nano 33 BLE

1349

August 5, 2021

Nano BLE TX pin always high IDE 1.x

407

May 5, 2021

Uploading sketch with Rx/Tx pin? Nano 33 BLE Sense

1954

October 12, 2021

How to send data from Arduino Nano 33 BLE to Arduino Nano? Programming

1856

October 23, 2022

Arduino Nano 33 BLE Sense vs Arduino Uno vs USB-to-TTL General Electronics

707

February 23, 2023

Tag » Arduino Nano 33 Ble Rx Tx

Nano 33 BLE Not Able To Communicate Using TX/RX - Arduino Forum

How Do I Use RX And TX For Arduino Nano Bbe? - Nano 33 BLE

Connecting Two Nano 33 BLE Sense Boards Through UART

How To Send Data From Arduino Nano 33 BLE To Arduino Nano?

Arduino Nano Ble 33 Rx/tx UART Problems

Serial Communication Between Arduino Nano 33 BLE Sense And ...

Adding An Additional UART Port In Arduino Nano 33 BLE

Nano 33 BLE Tx And Rx Pins 5V Tolerant?? - Arduino Forum

How Use 0(rx), 1(tx) Pins On Arduino Nano 33 Ble As Digital

Arduino Nano 33 BLE (nRF52840) Digital State Setting For TX Pin Not ...

Uploading Sketch With Rx/Tx Pin? - Nano 33 BLE Sense

Nano 33 BLE Sense Cheat Sheet - Arduino Documentation

Third Serial On Nano 33 BLE (can Be Software) - Arduino Forum

Nano 33 BLE Serial Port - Installation & Troubleshooting

Contact