No Web Interface On A Dell PowerConnect 6224 Switch - Vmexplorer
Maybe your like
No web interface on a Dell PowerConnect 6224 Switch
Posted on April 24, 2019 Updated on June 8, 2022
I picked up a Dell Powerconnect 6224 switch the other day as my older Netgear switch (2007) finally died. After connecting via console cable (9600,8,1,none) I updated the Firmware image to the latest revision. I then followed the “Dell Easy Setup Wizard”, which by the way stated the web interface will work after the wizard is completed. After completing the easy wizard I opened a browser to the switch IP address which failed. I then pinged the switch IP address, yep it is replying. Next, rebooted the switch – still no web interface connection.
How did I fix this?
1- While in the console, entered into config mode, and issued the following command.
console(config)#ip http server
2- Next I issued a ‘show run’ to ensure the command was present
console#show run !Current Configuration: !System Description “PowerConnect 6224, 3.3.18.1, VxWorks 6.5” !System Software Version 3.3.18.1 !Cut-through mode is configured as disabled ! configure stack member 1 1 exit ip address 172.16.74.254 255.255.255.0 ip default-gateway 172.16.74.1 ip http server username “admin” password HASHCODE level 15 encrypted snmp-server community public rw exit
3 – This time I connected to the switch via a browser without issue.

4 – Finally, saved the running-configuration
console#copy running-config startup-config
This operation may take a few minutes. Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Configuration Saved! console#
Summary: These were some pretty basic commands to get the http service up and running, but I’m sure I’ll run into this again and I’ll have this blog to refer too. Next, I’m off to setup some VLANs and a few static routes.
If you like my ‘no-nonsense’ blog articles that get straight to the point… then post a comment or let me know… Else, I’ll start writing boring blog content.
Share this:
- X
Related
Tag » How To Access Dell Switch Gui
-
Enable Web GUI Access On 3548 - Networking General - Dell
-
Use OpenManage Switch Administrator Web Interface (WEBGUI) On ...
-
Summary: Dell EMC Networking How To Access Management For The ...
-
How To Set Up Management Access For Dell Networking N2000 ...
-
User Interface - UI | Management Networks For Dell EMC Networking ...
-
Connect To The SmartFabric GUI - Dell Technologies InfoHub
-
[PDF] Dell Networking N20xx And N30xx Series Switch Installation Guide
-
Configure Access Mode Interfaces On Your N-Series Switch In OS6
-
Management Interface: Dell PowerConnect 5224 Systems User's ...
-
How Do I Enable Web Access On A Dell Powerconnect 5424
-
[PDF] Dell PowerConnect 3024 Systems User's Guide - Raru
-
[PDF] Dell™ Networking™ X1000 And X4000 Series Switches User Guide
-
How To Configure Dell N2024 Or N2048 Switch - Patrick Domingues
-
Cli Access - Dell Networking X1000 Series Getting Started Manual ...