SentrySafe - Need Help With Your Digital Lock? - Duro International

Most digital lock problems are related to low, dead or Non-Alkaline batteries. For all SentrySafe models, we recommend the following:

• DO NOT USE Rechargeable or Non-Alkaline batteries.
• Use quality name brand batteries.
• Purchase batteries from trusted sources.
• All batteries have expiration dates on them. Ensure those dates are as close to 10 years out from current year as possible.
• When changing batteries do not mix brands (i.e. all 4 batteries should be of the same brand) or mix old batteries with new batteries.
• It is strongly recommended to change batteries every 6 months to prevent battery leak.

Replacing batteries for your SentrySafe:

Model Nos: S6770, S7771, S8771

MSW0809, DA3930, DSW3930, OA3807, DSW5781, DSW5480

SFW082GTC, SFW123BDC, SFW123BSC, SFW123GTC, SFW205BXC, SFW205GPC, STW123GDC, STW205GYC

SFW123UDC, SFW205UPC

H060ES, HL100ES

X014E, X055, X075, X105, X125

T6-331, T8-331, T0-331

EF3428E, EF4738E, GS1459E, GS2459E, GS3659E

DH-074E, DH-134E

 

 

 

S6770, S7771, S8771

1. Slide open battery cover located just below keypad.
2. Insert a paper clip or pen point into small hold in the cover.
3. Push in while sliding cover to the right.
4. Remove battery holder.
5. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
6. Put battery hold back into safe.
7. Slide cover back into place.

  Slide open battery cover below keypad.

 

 

 

MSW0809, DA3930, DSW3930, OA3807, DSW5781, DSW5480

1. Check bottom edge of electronic lock and if equipped with shipping screw, remove and dispose of.
2. Turn electronic lock clockwise (right) and remove.
3. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
4. Ensure no wires are between keypad and mounting plate to avoid pinching of wires.
5. Replace the electronic lock and turn counterclockwise (left) to reattach.

  Turn electronic lock clockwise.

 

 

 

SFW082GTC, SFW123BDC, SFW123BSC, SFW123GTC, SFW205BXC, SFW205GPC, STW123GDC, STW205GYC

1. Pull out the battery drawer on side of electronic lock to the right.
2. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
3. Replace the electronic lock by sliding in to the left.

Pull out the battery drawer.

 

 

 

SFW123UDC, SFW205UPC

1. Remove battery compartment from inside door.
2. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
3. Replace battery compartment.

 

This safe has a Battery Auxiliary Override

1. If battery is low and unable to operate open, use Battery Auxiliary Override.
2. This should not be used as a primary means of gaining entry into safe.
3. Open the silicone cap found on the side of the electronic lock.
4. Insert a 9 volt battery into slot.
5. If attached properly, you will get 3 chirps from electronic lock.
6. Touch center of electronic lock to wake up keypad.
7. Enter 5 digit code, and turn handle to open.
8. Once opened follow instructions above to change batteries in compartment located inside of door.

Enter 5-digit code and turn handle to open.   Remove battery compartment from inside of safe door.

 

 

 

H060ES, HL100ES

1. Unscrew and remove override key lock cap.
2. Insert key and turn counterclockwise (left) to unlock door (notch on key in upward position).
3. Open door, remove battery compartment cover in direction arrows are pointing.
4. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
5. Slide battery compartment cover back into place (make sure cover is locked in place).

Override key lock cap.

 

 

 

X014E, X055, X075, X105, X125

Remove cover to override key between dial and keypad.

1. Insert key and turn counterclockwise (left), then turn dial clockwise (right) to open door.
2. Remove battery compartment cover in direction arrows are pointing.
3. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
4. Slide battery compartment cover back into place (make sure cover is locked in place).

 

  Slide open battery compartment cover.

 

 

 

T6-331, T8-331, T0-331

1. Turn electronic lock counterclockwise (left) and remove.
2. Unlock door with override key, pull handle down to open.
3. Remove key hook plate located on backside of door by sliding upward.
4. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
5. Ensure no wires are between keypad and mounting plate to avoid pinching of wires.
6. Slide key hook plate back into place (make sure cover is locked in place).

   Slide open battery compartment cover upwards.

 

 

 

EF3428E, EF4738EGS1459E, GS2459E, GS3659E

1. Push the electronic lock upwards.
2. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
3. Replace the electronic lock by sliding downwards.

Push the electronic lock upwards.

 

 

 

DH-074E, DH-134E

1. Turn electronic lock clockwise (right) and carefully pull away from mounting plate.
2. Insert 4-batteries as indicated (Do not use rechargeable, or Non-Alkaline. Do not mix old with new batteries or mix brands of batteries).
3. Carefully position keypad on mounting place.
4. Ensure no wires are between keypad and mounting plate to avoid pinching of wires.
5. Turn keypad counterclockwise (left) to attach to mounting plate.

  Turn electronic lock clockwise and pull away from mounting plate.