C1109 Battery Voltage ... - Nissan Maxima Service And Repair Manual

Nissan Maxima Service and Repair Manual: C1109 battery voltage [abnormal] Nissan Maxima Service and Repair Manual / Brakes / Brake control system / DTC/circuit diagnosis / C1109 battery voltage [abnormal]

Description

Supplies electric power to the ABS actuator and electric unit (control unit).

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAGNOSIS RESULTS

Check the self-diagnosis results.

Diagnosis Procedure

1.CONNECTOR INSPECTION

1. Turn ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) connector.
3. Check terminals for deformation, disconnection, looseness, and so on. If any malfunction is found, repair or replace terminals.
4. Reconnect connector and perform self-diagnosis

2.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY CIRCUIT AND GROUND CIRCUIT

1. Turn ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) connector.
3. Check voltage between ABS actuator and electric unit (control unit) connector E26 terminal 18 and ground

4. Turn ignition switch OFF.
5. Check continuity between ABS actuator and electric unit (control unit) connector E26 terminals 1, 4 and ground

Special Repair Requirement

1.ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

Always perform the neutral position adjustment for the steering angle sensor, when replacing the ABS actuator and electric unit (control unit).

C1105, C1106, C1107, C1108 wheel sensor

DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF DIAGNOSTIC RESULT With CONSULT. Start engine and drive vehicle at approximately 21 km/h (13 MPH) or more for approx ...

C1110, C1153, C1170 ABS actuator and electric unit (control unit)

DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSIS RESULTS Check the self-diagnosis results. Diagnosis Procedure 1.REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CO ...

Other materials:

Power supply and ground circuit BCM (BODY CONTROL MODULE) BCM (BODY CONTROL MODULE) : Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect BCM. Check voltage between BCM harness connector and ...

Diagnosis system (IPDM E/R) Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. Oil pressure warning lamp Front wiper (LO, HI) Parking lamps Side marker lamps License plate lamps Tail lamps Front f ...

Stop lamp Wiring Diagram ...