G83 Face Peck Drilling Cycle - KSI Swiss Support Vault

Skip to content

• Log In
• Account

Search For Search

1. Home
2. Knowledge Base
3. Programming
4. G Codes
5. Drilling Cycles
6. G83 Face Peck drilling cycle

1. Home
2. Knowledge Base
3. Programming
4. G Codes
5. G83 Face Peck drilling cycle

1. Home
2. Knowledge Base
3. Programming
4. G83 Face Peck drilling cycle

1. Home
2. Knowledge Base
3. TCM S Machine
4. G83 Face Peck drilling cycle

G83 Face Peck drilling cycle

G83-Face Peck drilling cycle. There are (2) parameters related to G83. Param #5101 bit2 (RTR) “High speed” if “0” then the pecks do NOT come out of the hole, they only back up the amount of Param #5114 “G83 Retract”, to break the chip and then start feeding again.

Param #5114 “G83 Retract -200” is the amount to rapid back into the hole from the last peck for clearance.

I suggest… Param #5101 bit2 = “1” -Rapid out of hole every peck. Param #5114 “G83 Retract” = “-200” =-.02 from last peck. No decimal.

G83 X(U)__C(H)__Z(W)__R__Q__P__F__K__M__ R= Distance from intial Point to R Point in radius P= Dwell time at bottom of Hole Q= Depth of cut for each cutting feed F= Feedrate in IPM(G98) or IPR(G99) K= Number of Repitions (When needed)

Note: G0,G1,G2 or G3 Cancel G83 Our factory recommends G80 to cancel

Example- M233 M233 T2222M50 G28H0M103S4000 G0X.15Z-.1 G83Z1.R.05Q0300P500F.003 H120.Q0300 H120.Q0300 G80 G0Z1.M105T0 G128 M230 M230

Z1. =Z position of the bottom of the hole

F.001 =Feed in IPR or IPM

R-.03 =Rapid from current Z position the R amount incrementally. If starting at Z-.05 and R=.03 then the Z axis rapidly positions to “Z-.02” and after every peck Z retracts to the same position “Z-.02”. If you use “R-.03” it is the same as “R.03”

Q2000 =Peck amount -same as .2 but not allowed a decimal point

P0 =Dwell amount at the bottom of the hole. You can just leave P off the command line if you want K = Number of Repeats

Was this article helpful? You must log in to vote Yes No

Related Articles

• Cross and back spindle bore size
• How to use tool life management
• TS205/TS265 Guide Bushing Print
• Private article
• DPI parameter on/off
• Private article

Need Support?

Can't find the answer you're looking for?Contact Support