Skip to main content Mitsubishi G4M3 Model 34 BETTY National Air and Space Museum DetailsRelated
Object Details
Manufacturer Mitsubishi Jukogyo K. K. Physical Description Forward fuselage Summary Few would know it by its official designation, the Navy Type 1 Attack Bomber. The Allies called it the BETTY but the men that flew the airplane nicknamed it the 'Hamaki,' Japanese for cigar, a reference to the airplane's rotund, cigar-shaped fuselage. The Japanese built more of them than any other bomber during World War II. From the first day of war until after the surrender, BETTY bombers saw service throughout the Pacific and Indian Oceans. Like the Mitsubishi Zero Fighter (also in the NASM collection), the Hamaki soldiered on long after it became obsolete, even dangerous, to fly wherever Allied interceptors prowled. Long Description Few would know it by its official designation, the Navy Type 1 Attack Bomber. The Allies called it the BETTY but to the men that flew the airplane, it was popularly, but unofficially, the 'Hamaki,' Japanese for cigar, in honor of the airplane's rotund, cigar-shaped fuselage. The Japanese built more of them than any other bomber during World War II. From the first day of war until after the surrender, BETTY bombers saw service throughout the Pacific and Indian Oceans. Like its stablemate, Mitsubishi's Zero Fighter (see NASM collection for two examples), the Hamaki soldiered on long after it became obsolete, even dangerous, to fly wherever Allied interceptors prowled. In July 1937, the new Mitsubishi G3M bomber (Allied codename NELL) went into service in China. Only two months later, the Navy issued a specification to Mitsubishi for a NELL replacement. At that time, the requirements were unprecedented for a twin-engine, land-based attack bomber: flying at a top speed of 398 kph (247 mph) and an altitude of 3,000 m (9,845 ft), the new bomber had to fly a distance of 4,722 km (2,933 miles) without a torpedo or equivalent weight in bombs. When carrying an 800-kg (1,768 lb) torpedo or the same weight in bombs, the Navy needed the bomber to fly at least 3,700 km (2,300 mi). To meet the requirements, a Mitsubishi design team led by Kiro Honjo crafted an airplane called the G4M with fuel tanks in the wings that were not resistant to explosion when punctured during combat. These tanks were much lighter in weight than explosion-proof (also called 'self-sealing') gas tanks. The decision not to incorporate the heavier, safer fuel tanks was necessary to meet the Navy's range requirements. Mitsubishi incorporated this same design feature in the Zero, for the same reasons and with the same results. Both aircraft had unprecedented range but they were also extremely vulnerable to the machine gun and cannon fire from Allied fighter aircraft. The BETTY was so prone to ignite that the Allies nicknamed it the 'flying lighter.' The fuselage was streamlined but rotund to allow space for a bomb bay within the wing center section and to allow the 7 to 9-man crew to move about. About half the crew manned the defensive gun positions. Bomber crews flying the NELL were virtually incapable of defending themselves from concentrated fighter attacks, so Honjo paid special attention to this aspect of the G4M. He incorporated 7.7 mm (.30 cal.) guns in the nose, atop the mid-fuselage behind the cockpit, and on both sides of the fuselage behind the wing. In the tail, he introduced a 20 mm cannon. Although the G4M now had a more potent sting, Honjo again sacrificed crew protection to the Navy's demands for great range. He omitted armor plate. The first G4M prototype left the factory in September 1939 and made the trek to Kagamigahara Airfield since Mitsubishi's Nagoya plant had no company airstrip. Kagamigahara was 48 km (30 miles) to the north. Japan's newest and most advanced bomber made the trip, disassembled and stacked on five ox-drawn farm carts, over unpaved roads! After arriving at the airfield, the first G4M was reassembled and flown by test pilot Katsuzo Shima on October 23, 1939. Initial results were impressive, but the Navy shelved the bomber for a time in favor of a variant to be called the G6M1. Navy leaders hoped that by increasing the number of defensive cannons, the G6M1 could become a heavy escort fighter for other bombers but this diversion failed to live up to expectations, and the Navy ordered the G4M1 into production. The U. S. Army Air Corps conducted a similar experiment using a modified Boeing B-17 bomber designated the B-40 but this idea too failed to survive operational testing and was soon abandoned. The first production G4M rolled off the line in April 1941. For the remainder of the war, the BETTY assembly line continued to run. Operationally, BETTY crews achieved much in their first year of combat. They devastated Clark Field, Philippine Islands, on December 8, 1941, and participated in sinking the British battleships HMS "Prince of Wales" and HMS "Repulse" on December 10. They ranged across the length and breadth of the Pacific Theater, attacking targets from the Aleutians to Australia. Against limited fighter opposition, the lack of armor and self-sealing fuel tanks was no hindrance. The savings in airframe weight allowed the G4M to attack targets at unprecedented ranges. But as Allied fighter strength increased, the BETTY began to reveal its fatal vulnerabilities. Admiral Isoroku Yamamoto, architect of the Pearl Harbor attack, died on April 18, 1943, along with his entire staff when U. S. Army Air Corps P-38 Lightnings (see NASM collection) intercepted and destroyed the two BETTY bombers that carried them. Six escorting Zeros flew guard but in a matter of seconds, the Air Corps pilots shrugged off the escorting fighters and sent both BETTYs crashing down in flames. As the war dragged on, improved bombers failed to materialize so Mitsubishi fielded different versions of the G4M to fulfill new missions, and to eliminate the various weaknesses in the basic design. Front-line combat units operated many variants and subvariants with different engines and armament packages. The G4M2 was a complete redesign but it did not overcome the airplane's vulnerability to Allied firepower. Mitsubishi tried again to reduce the bomber's tendency to burn. The firm changed the wing to a single-spar configuration and installed self-sealing fuel tanks with a capacity about one-third less than earlier versions. The capacity dropped because of the material inserted in the tank to block leaking fuel when gunfire perforated the tank. Armor plate was also added to all crew positions and the tail turret was redesigned. As a result of these modifications, the fuselage was shortened and the center-of-gravity shifted forward. To re-balance the bomber, dihedral was added to the horizontal stabilizer. This version was called the G4M Model 34. Another BETTY variant became mother ship to the Kugisho Ohka kamikaze, or Tokko (special attack) aircraft (see NASM collection). It is estimated that by the end of the war, 5,000 pilots had died making Tokko attacks and the damage they wrought was severe. During the invasion of Okinawa in April 1945, the U. S. Navy lost 21 vessels sunk and 217 damaged. Casualties were horrific. Navy crews suffered 4,300 fatalities and 5,400 casualties, or seven percent of all crew casualties incurred during the entire Pacific war. Mitsubishi produced a total of 2,414 G4M airplanes but few remained when the war ended on August 15, 1945. Four days later, two BETTY bombers landed at Ie Shima Island. They were painted in special 'surrender markings,' white overall with green crosses replacing the Japanese Hinomaru or red "meatball" national insignia. The official Japanese surrender delegation had boarded these two BETTYs in Kyushu. Their next stop was the Philippines where the Allied delegation, led by General Douglas MacArthur, would witness the Japanese officials signing the surrender agreement. The end had arrived for the Japanese and the BETTY bomber. The NASM G4M Model 34 BETTY is not complete but it is the best-preserved example of this famous aircraft in the world. Two major portions survive: the nose including the entire flight deck, and ten feet of the fuselage. The aircraft was probably based at Oppama Air Field near Yokosuka, Japan, but no record of the unit or service history is known. It was brought to the United States aboard a U. S. Navy aircraft carrier along with 145 other Japanese aircraft selected for test and evaluation. This BETTY was flight-tested as Foreign Equipment Test number T2-2205. Later, the airplane was dismembered with a cutting torch but when and precisely why are not known. Evidently, only the pieces that survive today arrived at the storage facility at Park Ridge, Illinois, during the late 1940s. Credit Line Transferred from the U.S. Air Force 1939 Inventory Number A19600336000 Restrictions & Rights Usage conditions apply Type CRAFT-Aircraft Dimensions Overall: 19ft 8 1/4in. x 63ft 11 11/16in., 15432.2lb., 82ft 1/4in. (6m x 19.5m, 7000kg, 25m) Country of Origin Japan See more items in National Air and Space Museum Collection National Air and Space Museum Record ID nasm_A19600336000 Metadata Usage (text) Not determined GUID (Link to Original Record) http://n2t.net/ark:/65665/nv9aeddf811-0b87-4487-8367-f8248b7c9f2b
Related Content
Aircraft
Air and Space Museum
CC0 Creative Commons - No Rights Reserved icon Usage Conditions Apply> download icon > There are restrictions for re-using this image. For more information, visit the Smithsonian's Terms of Use page . International media Interoperability Framework IIIF provides researchers rich metadata and media viewing options for comparison of works across cultural heritage collections. Visit the IIIF page to learn more. View manifest View in Mirador Viewer Expand to view image × PreviousNextBack to Top
Previous Next Back to Top 
