Pin Cho Iphone 4S | Supitec

Trang chủ » độ Pin Iphone 4s » Pin Cho Iphone 4S | Supitec

Có thể bạn quan tâm

Đặc tính kỹ thuật của sản phẩm:

Tổng số lần sạc 500 - 800 lần sạc
Tuổi thọ của sản phẩm 2 - 3 năm
Dung lượng 1430mAh（5.3whr）
Điện áp định mức 3.7V
Điện áp nạp Max.4.2V
Kích thước pin (4.2±0.2)*(32±0.5)*(82±1)mm
Nhiệt độ làm việc -20~50℃

Hướng dẫn thay thế sản phẩm:

Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

Push the rear panel toward the top edge of the iPhone.

Pull the rear panel away from the back of the iPhone, being careful not to damage the plastic clips attached to the rear panel.

Remove the following screws securing the battery connector to the logic board:

Remove the following screws securing the battery connector to the logic board:

One 1.7 mm Phillips screw.

One 1.5 mm Phillips screw.

Use a plastic opening tool to pull the pressure contact from underneath the battery connector.

When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to create wireless interference.

Use a plastic opening tool to pull the pressure contact from underneath the battery connector.When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to create wireless interference.

Take notice of the position of the small black ground clip on the upper screw of the battery connector. This clip is attached only by the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.

Insert the edge of a plastic opening tool between the battery and the outer case near the bottom of the iPhone.

Insert the edge of a plastic opening tool between the battery and the outer case near the bottom of the iPhone.

Run the plastic opening tool along the right edge of the battery and pry up at several points to completely separate it from the adhesive securing it to the outer case.

Use the exposed clear plastic pull tab to peel the battery off the adhesive securing it to the iPhone.

Use the exposed clear plastic pull tab to peel the battery off the adhesive securing it to the iPhone.Be careful not to pull the plastic pull tab too hard as it can be ripped off very easily.

Từ khóa » độ Pin Iphone 4s