Removing And Installing Engine Speed Sender -G28 - Volkswagen Golf

Trang chủ » Vw Golf G28 » Removing And Installing Engine Speed Sender -G28 - Volkswagen Golf

Có thể bạn quan tâm

  • Manuals
  • Golf OM
  • Golf SM
  • Download Manual
  • ID.3 Service Manual
  • ID.4
  • ID.7
  • Taos
  • New
  • Top
  • Sitemap
  • Search
VW Golf manuals Volkswagen Golf Service & Repair Manual: Removing and installing engine speed sender -G28- Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Ignition system, glow plug system / Removing and installing ignition coils with output stage / Removing and installing engine speed sender -G28-

Special tools and workshop equipment required
Socket AF 4 mm -T10370-
Removing
– Remove noise insulation → General body repairs, exterior; Rep. gr.66.

Removing and installing engine speed sender -G28-

– Unscrew bolt -arrow- and push charge air cooling pump -V188- to one side.

Removing and installing engine speed sender -G28-

– Disconnect electrical connector -1-.
– Unscrew bolt -2- and remove engine speed sender -G28-.
Installing
Note
Carefully insert engine speed sender -G28- in bore!
This will prevent the engine speed sender -G28- from falling between engine and gearbox.
– Install in reverse order.
– Install noise insulation → General body repairs, exterior; Rep. gr.66.
Specified torques
→ Chapter „Assembly overview - ignition system“
→ Chapter „Assembly overview - electric coolant pump“

Removing and installing engine speed sender -G28-

Removing and installing Hall sender 3 -G300-
Removing – Release hose clips -1- and -2-, and remove air pipe. ...

Fuel supply system - Petrol engines
...

Other materials:

Removing and installing throttle valve module -GX3- Throttle valve module -GX3- consists of Throttle valve module -J338- Throttle valve drive for electronic power control -G186- Throttle valve drive angle sender 1 for electronic power co ...

Removing and installing oil pressure switch -F1- Special tools and workshop equipment required Jointed wrench 24 mm -T40175- Removing Note Fit all heat insulation sleeves in the original posi ...

Indicator lamps First read and observe the introductory information and safety warnings  Lit up Possible cause Solution The vehicle is being held by the electronic parking brake. Switch off the Auto Hold function if necessary   . ...

© 2016-2026 Copyright www.vwgolf.org

Từ khóa » Vw Golf G28