TDS Meter Sensor With Arduino DFROBOT : 4 Steps - Instructables

Trang chủ » Cảm Biến Tds Arduino » TDS Meter Sensor With Arduino DFROBOT : 4 Steps - Instructables

Có thể bạn quan tâm

Introduction: TDS Meter Sensor With Arduino DFROBOT

Gauravkumar5By Gauravkumar5www.techeonics.comFollowMore by the author:Automatic Fan Controller Based on Temperature With UA741 ICUpgrade Flysky Fs-i6 Firmware to 10 ChannelsMaxSonar EZ0 Ultrasonics Sensor With Arduino

TDS (Total Dissolved Solids) indicates how many milligrams of soluble solids are dissolved in one liter of water. In general, the higher the TDS value, the more soluble solids are dissolved in water, and the less clean the water is. Therefore, the TDS value can be used as one reference point for reflecting the cleanliness of water.

In this project, we will interface Gravity Analog TDS Sensor with Arduino Microcontroller and read the value in a 16×2 LCD Display (with i2c module)

For More :- https://techeonics.com/turbidity-sensor/

Website :- https://techeonics.com/

Github :- https://github.com/gauravk5/Techeonics-Arduino-Cod...

Supplies

Materials

Following are the components required for making this project.

*TDS METER:- https://amzn.to/3thcVQ5

*LCD With I2C Module:- https://amzn.to/3thcVQ5

*ArduinoUNO:- https://amzn.to/3thcVQ5

*TDS Meter Sensor:- https://amzn.to/3thcVQ5

Step 1: Connect TDS Sensor With Arduino

VCC = 5V

GND = GND

A = A1

Step 2: Connect LCD With Arduino

VCC = 5V

GND = GND

SDA = A4

SCL = A5

Step 3: CODE

GITHUB :- https://github.com/gauravk5/Techeonics-Arduino-Cod...

Step 4: VIDEO

Hide

Từ khóa » Cảm Biến Tds Arduino