How To Clean A Honda Map Sensor - It Still Runs

Maybe your like

How to Clean a Honda Map Sensor by Alibaster Smith

The manifold absolute pressure sensor, or MAP sensor, is used to measure the amount of air flowing through the intake system and into the engine. The sensor sends airflow rate data to the Honda engine control unit, or ECU, which can then adjust the air-to-fuel ratio for optimum fuel combustion. Over time, the Honda MAP sensor can become dirty with contaminates or dust in the air. When this happens you'll need to clean the sensor.

Step 1

Open the hood and locate the MAP sensor. Honda MAP sensors are located near the intake manifold. The exact location varies depending on the year and model of Honda. The sensor itself is a small black box.

Step 2

Remove the electrical plug running to the MAP sensor. Squeeze the release tab on the top of the plug and pull the connector off.

Step 3

Remove the screws holding the MAP sensor in place and remove the sensor.

Step 4

Turn the sensor upside down on a flat surface so that the sensor end of the MAP sensor is exposed.

Step 5

Spray the sensor liberally with electronic parts cleaner. Remove any visible signs of dust or other contaminates. The electronic parts cleaner will evaporate, so there is no need to wipe it down.

Step 6

Re-install the MAP sensor. Installation is the reverse of removal.

Tips

For specific information about removing your Honda MAP sensor, consult the particular vehicle's manual (see Resources).

Things You'll Need

Screwdriver
Electronic parts cleaner

Writer Bio

I am a Registered Financial Consultant with 6 years experience in the financial services industry. I am trained in the financial planning process, with an emphasis in life insurance and annuity contracts. I have written for Demand Studios since 2009.