KY-026 Flame Sensor Module - ArduinoModulesInfo

The KY-026 Flame Sensor module detects infrared light emitted by fire. This module has both digital and analog outputs and a potentiometer to adjust the sensitivity. Commonly used in fire detection systems.

Compatible with Arduino, Raspberry Pi, ESP32 and other microcontrollers.

KY-026 Specifications

This module consist of a 5mm infra-red receiver LED, a LM393 dual differential comparator, a 3296W trimmer potentiometer, 6 resistors,2 indicator LEDs and 4 male header pins. The board features an analog and a digital output.

Operating Voltage	3.3V ~ 5.5V
Infrared Wavelength Detection	760nm ~ 1100nm
Sensor Detection Angle	60°
Board Dimensions	1.5cm x 3.6cm [0.6in x 1.4in]

Connection Diagram

Connect the board’s analog output (A0) to pin A0 on the Arduino and the digital output (D0) to pin 3.

Connect the power line (+) and ground (G) to 5V and GND respectively.

KY-026	Arduino
A0	Pin A0
G	GND
+	+5V
D0	Pin 2

KY-026 Arduino Code

In this Arduino sketch we’ll read values from both digital and analog interfaces on the KY-026, use a lighter or a candle to interact with the flame detector module.

The digital interface will send a HIGH signal when fire is detected by the sensor, turning on the LED on the Arduino (pin 13). Turn the potentiometer clock-wise to increase the detection threshold and counter-clockwise to decrease it.

The analog interface with return a high numeric value when there’s no flame near and it’ll drop to near zero in the presence of fire.

int led = 13; // define the LED pin int digitalPin = 2; // KY-026 digital interface int analogPin = A0; // KY-026 analog interface int digitalVal; // digital readings int analogVal; //analog readings void setup() { pinMode(led, OUTPUT); pinMode(digitalPin, INPUT); //pinMode(analogPin, OUTPUT); Serial.begin(9600); } void loop() { // Read the digital interface digitalVal = digitalRead(digitalPin); if(digitalVal == HIGH) // if flame is detected { digitalWrite(led, HIGH); // turn ON Arduino's LED } else { digitalWrite(led, LOW); // turn OFF Arduino's LED } // Read the analog interface analogVal = analogRead(analogPin); Serial.println(analogVal); // print analog value to serial delay(100); }

Use Tools > Serial Plotter on the Arduino IDE to visualize the values on the analog interface, in this example we used a lighter to create a small flame every couple of seconds. You can see the values decreasing as the flame gets closer to the sensor and then increasing when the flame moves away from the sensor.

Downloads

• Fritzing Part: KY-026 Flame Detector Sensor Module.
• LM393 comparator datasheet.
• 3296W-104 trimmer datasheet.