Changing Bulbs In The Halogen Headlights - Volkswagen Golf

Volkswagen Golf Owners Manual: Changing bulbs in the halogen headlights Volkswagen Golf Owners Manual / If and when / Practical tips / Changing bulbs / Changing bulbs in the halogen headlights

Fig. 234 In the engine compartment: covers on the left front headlight ① dipped beam, ② main beam, side lights and daytime running lights, ③ turn signal

First read and observe the introductory information and safety warnings

The front headlight does not need to be removed when changing bulbs.

The actions should only be carried out in the specified order:
①	②		③
Dipped beam headlights	Side light (small bulb holder)	Main beam/daytime running lights or daytime headlights	Front turn signal
1.	Observe and follow the instructions on the checklist.
2.	Open the bonnet .
3.	Remove the rubber cover on the rear of the headlight. Depending on the model, a hard plastic cover may also be fitted. Turn the cover anticlockwise and remove it.
4.	Turn the bulb holder anticlockwise as far as it will go and carefully pull it out to the rear along with the bulb.			Pull the bulb holder and the bulb out to the rear, and carefully guide them sideways out of the opening.
5.	Replace the defective bulb with a new bulb of the same type.
6.	With the retaining lug facing upwards B ①, insert the bulb holder into the headlight and turn it clockwise as far as it will go.			Carefully insert the bulb holder into the headlight and push it towards the front until it clicks into place.
7.	Attach the rubber cover or hard plastic cover and turn it clockwise as far as it will go.

The illustrations show the left-hand headlight from the rear. The right-hand headlight is a mirror image of the one shown.

There are various types of front headlight, so the position and design of covers, bulbs and bulb holders may vary from those shown in the illustrations.

It is not possible to change the LEDs of a daytime running light with LED technology. Proceed to a qualified workshop.

Checklist

Always carry out the following actions for changing a bulb in the given order : Park the vehicle on a firm and level surface at a safe distance from the flow of traffic. Switch on the ...

Changing bulbs in xenon headlights

Fig. 235 In the engine compartment: ① cover in left-hand xenon headlight, ② cornering light, ③ turn signal, ④ side light and daytime running light First read and observe the introductory ...

Other materials:

Checking auxiliary air heater element -Z35- with auxiliary air heater control unit -J604-, LHD vehicles Checking Special tools and workshop equipment required Vehicle diagnostic tester with current probe 100 A -VAS 5051B/7- Test conditions Intake temperature less th ...

Incorporation of heat exchanger for high-voltage battery into coolant circuit of high-voltage system Note Fill coolant and bleed coolant circuit → Rep. gr.19. The illustration below shows only some of the components of the coolant circuit for the high-voltage system. For components which are not sho ...

Removing and installing support for luggage compartment floor, estate Special tools and workshop equipment required Removing – Fold down rear seat backrests. – Turn fasteners on left and right of luggage c ...