Cv Value & Flow Rate Calculator｜Product & Technical Support

Trang chủ » Cv M3/h » Cv Value & Flow Rate Calculator｜Product & Technical Support

Có thể bạn quan tâm

Product Information
  1. HOME
  2. Product & Technical Support
  3. Cv Value & Flow Rate Calculator
Cv Value & Flow Rate Calculator

What is Cv value?

The valve flow coefficient according to the JIS standard, represents the flow capacity in US gallons/minute of 60° F pure water when it is flowing through the valve with a pressure difference of 1 psi at the specified travel (operation range).

Cv value and flow rate calculation

Calculating the flow rate from the Cv value requires complex calculations. We have created a Cv value and flow rate calculator, so please utilize it.

If you want to calculate the Cv value and flow rate outside of the specified units, please contact us.

1 Select calculation method Cv value Flow rate
2 Select fluid type Liquid Gas
Enter specific gravity
3 Enter flow rateSelect unit Select unit
4 Select pressure With both gas and liquid vacuum (negative pressure), enter the absolute pressure Gaugepressure Absolutepressure
Select pressure unit Select pressure unit kPa MPa mbar bar psi mmH2O mmHG atm kgf/cm2
Enter pressure
Differential pressure
Reference Cv value00.00 ※ Depends on the following formulas.
Cv値計算式及び流量計算（Cv値から）式 【Explanation of symbols】 QL [m3/h] : Liquid flow rate（h : hours） Qg [m3/h (normal) ] : Gas flow rate in standard conditions (15℃ 0.1013 MPa abs) P1 [MPa abs] : Primary absolute pressure ※3 P2 [MPa abs] : Secondary absolute pressure ※3 t [℃] : Fluid temperature GL : Liquid relative density（Water = 1） Gg : Gas relative density（Air = 1） 【Notes on use】 ※1 Please handle the calculation result as reference value. It is a standard for selection of valves, depending on the specific piping conditions and conditions of use, there is a possibility that actual results may differ from calculation results. ※2 Calculation of viscosity correction is necessary when the fluid is liquid and the kinematic viscosity is 20 mPa・s or more and the calculated Cv value is 0.01 or less. Please contact us if the fluid specification requires viscosity correction. ※3 For P1 and P2, please use pressure close to the valve. If calculation is made using the pressure at the point away from the valve, large errors may occur in the calculation results due to pressure loss etc. of piping. Return to Product & Technical Support Inquiries

Từ khóa » Cv M3/h