Have A VigoEngraver VG-L7. Travel Lines - LightBurn Software Forum

Trang chủ » Vigo Engraver L7 Alternative » Have A VigoEngraver VG-L7. Travel Lines - LightBurn Software Forum

Có thể bạn quan tâm

Have a VigoEngraver VG-L7. Travel lines LightBurn Hardware Compatibility October 8, 2020, 4:54am 1

When engraving using your software. my laser will not shut off when moving to a new line to engrave. like in images there are travel lines to the next spot to be engraved. I’m not very tech savy.

October 8, 2020, 10:52pm 2 Small lines between each letter Vigotec VG-L5 5w 450nm LightBurn Software Questions

Which has this link:

Laser not turning off between cuts? (burning during travel moves) Resources
If you have a GRBL device, and your laser is still on when moving between shapes, like this: [image] It most likely means you are using GRBL 1.1f or later, but do not have the controller in Laser Mode. Fix this by typing $32=1 in the Console window and pressing enter If you have a Ruida or other DSP controller and are seeing this happen, it is most likely a dying high-voltage power supply unit (PSU). The drive circuit that turns the laser power off and on tends to go first, before the part …
November 7, 2020, 10:52pm 3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.

Unfortunately, your browser is unsupported. Please switch to a supported browser to view rich content, log in and reply.

Từ khóa » Vigo Engraver L7 Alternative