Operating Instructions, Using Your Vicks Warm Mist Humidifier

Operating Instructions

1.

Do not operate the humidifier without water in the Water Tank or without the RemovableWater Tray, Cooling Chamber and Medicine Cup installed.

2.

After filling the humidifier, be sure the Power Switch is in the OFF position, then plug thepower cord into a 120 volt AC wall outlet. DO NOT PLUG IN THE CORD WITH WETHANDS; ELECTRIC SHOCK COULD RESULT.

3.

You can use Kaz Inhalant or Vicks VapoSteam with your Vicks Warm Mist Humidifier.Remove the Medicine Cup from the unit for easier filling and replace on top of theCooling Chamber. Be careful not to overfill the Medicine Cup or spill anything into theCooling Chamber.

4.

Turn the Switch to either the Hi or Low position. The Night Light will illuminate and theheater will start. It may take several minutes before mist will appear at the outlet.

5.

Direct Outlet away from walls and furniture. If condensation forms on walls or windows,or if indoor relative humidity exceeds 50%, turn the Switch to the low setting, open doorto room where humidifier is operating, or turn unit off.

6.

Turn the humidifier off before removing and refilling the Water Tank.

Reset Procedure

NOTE: When the water tank is empty and the water in the Heating Chamber is almost used

up, the Heater will automatically shut off. The Reset Light will illuminate to indicate that thehumidifier is out of water. The humidifier will not operate until the water tank is refilled and thehumidifier is reset.

1.

Turn the Power Switch to the Off position. Unplug the humidifier. Allow the humidifier tofully cool for at least 15 minutes.

2.

Remove and refill the Water Tank as instructed in the "Filling The Water Tank" sectionabove.

3.

After filling the humidifier, plug the power cord into a 120 volt AC wall outlet. DO NOTPLUG IN THE CORD WITH WET HANDS; ELECTRIC SHOCK COULD RESULT.

4.

The Reset Light should now be off. Some models have a Reset Button. Push the ResetButton on those models to re-engage the heater.

5.

Turn the Switch to either the Hi or Low poisition. The Nightlight will illuminate and theheater will start. It might take several minutes before mist will appear at the outlet.

Using Your Vicks Warm Mist Humidifier

First Time Use

Read all instructions before using this appliance. With proper care and maintenance,the humidifier should be able to provide at least 12 hours of operation for each tank.

Unpack and remove all packing material from the Water Tank and Base. Completely unravelpower cord and place unit on a flat, stable surface at least 5 inches away from walls and heatsources. Do not use product if cord has been damaged. Place cord out of the way where itcannot be pulled or stepped on. Follow the directions below to fill and operate the Humidifier.

Filling the Water Tank

Always UNPLUG the humidifier before filling.

1.

Remove the Water Tank from the Base and turn it upside down. Turn the Tank Capcounterclockwise to open.

2.

Fill the Water Tank with clean, cool, tap water and replace the Tank Cap by firmly turningclockwise. Turn the tank upright and check Tank Cap for leaks. If any water drips fromTank Cap, remove it and re-tighten.

3.

Carry Water Tank using one hand on the top handle and one on the bottom of the Tank.

4.

Be sure the Removable Water Tray and Cooling Chamber are in place and the CoolingChamber Interlock is engaged.

5.

Replace the Water Tank on the Base by aligning the Tank Cap into the Water Tray.

Caution:

Do not

add any medication or other additives to the water.

Do not pour any water into the outlet.