Back Up Light Switch Inspection - Exterior - Mazda 3 Service Manual

Mazda 3 Service Manual: Back Up Light Switch Inspection Mazda 3 Service Manual / Body / Lighting & Horn / Exterior / Back Up Light Switch Inspection

1. Disconnect the negative battery cable..

2. Remove the battery component. (ex: battery, battery tray and PCM component) (G35-MR,G66M-R).

3. Remove the aerodynamic under cover No.2. (G35-MR,G66M-R,C66M-R).

4. Disconnect the back-up light switch connector..

5. Verify that the continuity between the back-up light switch terminals is as indicated in the table.

• If not as indicated in the table, replace the back-up light switch.

Rear Combination Light Removal/Installation

4SD 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk mat. b. Trunk board. c. Trunk end trim. d. Trunk side trim. 3. Disconnect the connectors shown in th ...

Back Up Light Switch Removal/Installation [A26 M R]

1. Disconnect the negative battery cable. 2. Disconnect the back-up light switch connector. 3. Remove the aerodynamic under cover No.2.. 4. Remove the back-up light switch with the gasket. ...

Other materials:

Camshaft Position (CMP) Sensor Inspection [Mzr 2.0, Mzr 2.5] Visual Inspection CAUTION: When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration i ...

Electric Variable Valve Timing Motor/Driver Removal/Installation [Skyactiv G 2.0] WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. CAUTION: Applying excessive force (force of 100 N {10.2 kgf, 22.5 lbf} or more) to the electric variable valve timing motor/driver may cause a malfunction. When ...

Oil Pressure Switch Inspection [FS5 A EL] CAUTION: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it. On-Vehicle Inspection 1. Perform the following procedures. a. Remove the aerodynamic under co ...