Suzuki GSX-R 1000 Service Manual: Self-diagnosis Function

Suzuki GSX-R 1000 Service Manual: Self-diagnosis function Suzuki GSX-R 1000 Service Manual / Engine / Engine general information and diagnosis / General description / Self-diagnosis function

The self-diagnosis function is incorporated in the ecm. The function has two modes, “user mode” and “dealer mode”.

The user can only be notified by the lcd (display) panel and led (fi indicator light). To check the function of the individual fi system devices, the dealer mode is provided. In this check, the special tool is necessary to read the code of the malfunction items.

User mode

*1

When one of the signals is not received by ecm, the fail-safe circuit works and injection is not stopped. In this case, “fi” and odd / trip / clock / panel light brightness / lap time counter are indicated in the lcd panel and motorcycle can run.

*2

The injection signal is stopped, when the camshaft position sensor signal, crankshaft position sensor signal, tip-over sensor signal, #1, #2, #3 and #4 ignition signals, #1, #2, #3 and #4 injector signals, fuel pump relay signal or ignition switch signal is not sent to ecm. In this case, “fi” is indicated in the lcd panel. Motorcycle does not run.

“Chec”:

the lcd panel indicates “chec” when no communication signal from the ecm is received for 5 seconds.

For example:

the ignition switch is turned on, and the engine stop switch is turned off. In this case, the speedometer does not receive any signal from ecm, and the panel indicates “chec”. If chec is indicated, the lcd does not indicate the trouble code. It is necessary to check the wiring harness between ecm and speedometer couplers.The possible cause of this indication is as follows: engine stop switch is in off position. Side-stand/ignition inter-lock system is not working. Ignition fuse is burnt.

“Sd”:

the lcd panel indicates “sd” when the steering damper solenoid malfunction, battery abnormal voltage and speed sensor malfunction occurred.

Dealer mode

The defective function is memorized in the computer. Use the special tool’s coupler to connect to the mode select switch. The memorized malfunction code is displayed on lcd (display) panel. Malfunction means that the ecm does not receive signal from the devices. These affected devices are indicated in the code form.

Caution before checking the malfunction code, do not disconnect the ecm coupler. If the coupler from the ecm is disconnected, the malfunction code memory is erased and the malfunction code can not be checked.

Special tool (a): 09930–82720 (mode selection switch)

Injection timing description

Injection time (injection volume) The factors to determine the injection time include the basic fuel injection time, which is calculated on the basis of the intake air pressure, engine speed and t ...

Schematic and routing diagram

FI system wiring diagram Terminal alignment of ecm coupler ...

Other materials:

Specifications Service data Drive train unit: mm (in) except ratio Tightening torque specifications Note the specified tightening torque is described in the following. “Drive chain related components” Reference: for the tightening torque of fastener not specified in this section ...

Clutch removal Drain engine oil. Refer to “engine oil and filter replacement” in section 0b . Lift and support the fuel tank with the prop stay. Refer to “fuel tank removal and installation” in section 1g . Disconnect the ckp sensor coupler (1). Remove the clutch cover (2). ...

Exhaust control system description The exhaust control system (excs) consists of the exhaust control valve (excv), exhaust control valve actuator (excva) and exhaust control valve cables (excv cables). Excv is installed in the exhaust pipe. Excva is mounted inside of the right frame. The excv is operated by the excva via the ...